AOC SFP+ Active Optical Cable CBO CBL-SFP+AOC-20M 20 m length

The AOC SFP+ Active Optical Cable CBO CBL-SFP+AOC-20M 20 m length is a factory-terminated optical interconnect designed for SFP+ ports. This BlueOptics cable integrates active optics directly into the SFP+ form factor, enabling 10 Gb/s class links over a 20 metre distance without the need for separate transceivers. The assembly delivers electrical-to-optical conversion in each connector, providing low latency and immunity to electromagnetic interference while reducing rack space and simplifying cabling in server, switch and storage environments.

Advantages

This 20 m active optical cable offers plug-and-play compatibility with SFP+ ports, eliminating the time and cost of installing separate transceivers and patch fiber. The integrated optical design reduces signal loss across the link and provides consistent performance over the full 20 m span. Its immunity to EMI and reduced heat generation compared with copper alternatives support stable operation in dense installation scenarios. The single-cable solution simplifies inventory and maintenance by combining connector and optical medium in a single unit.

Suitable for

• High-speed links between servers and top-of-rack or leaf switches in data centres
• Interconnects between storage arrays and host controllers
• Short-run optical connections where SFP+ port compatibility is required
• Environments sensitive to electromagnetic interference

Key specifications

• Connector type: SFP+ form-factor active optical connectors at both ends
• Maximum supported data rate: compatible with 10 Gb/s SFP+ links
• Cable length: 20 metres
• Transmission medium: single-mode or multimode active optical assembly (factory-terminated)
• Latency: low propagation delay suitable for latency-sensitive applications
• EMI immunity: inherent optical transmission resists electromagnetic interference
• Powering: active components powered via SFP+ port interface

How to use

Install the cable by inserting each SFP+ end into the corresponding SFP+ port on your network devices until the connector latches. Confirm link status via the devices' port LEDs or management interface and verify negotiated speed and duplex settings. No separate transceivers or patch fiber are required; treat the assembly as a direct attach cable that provides optical connectivity. For removal, release the connector latch and withdraw the module straight out to avoid stressing the cable or port.

Recommendations

Ensure the SFP+ ports on both devices support active optical cable modules and the same link speed. Route the 20 m cable to avoid sharp bends and excessive tension; follow minimum bend radius guidelines from the device vendor. Use this cable in controlled environments typical of data centres and enterprise racks, and verify firmware or compatibility lists if your hardware vendor publishes supported AOC modules.