BlueOptics AOC-QSFP-100G-2M-BO InfiniBand fibre optic cable 2m QSFP28 Male/Male

The BlueOptics AOC-QSFP-100G-2M-BO InfiniBand fibre optic cable is a 2-meter active optical cable with QSFP28 male connectors on both ends, designed for high-speed interconnects in data centers and enterprise networking environments. The cable supports 100G data rates over a short reach and is intended for use in switch-to-switch, switch-to-server, and server-to-server connections where compact, low-latency links are required.

Advantages

This BlueOptics AOC provides full-duplex 100G transmission with low insertion loss and consistent signal integrity across the 2 m length. The QSFP28 male terminations enable direct plug-and-play connectivity with QSFP28 ports, reducing the need for transceivers and simplifying cabling. The assembled active optical design offers lower power consumption compared with some copper alternatives and improves thermal behavior in dense rack environments.

Suitable for

• High-density data centre switch-to-switch interconnects
• Server-to-server links in compute clusters
• Top-of-rack (ToR) and leaf-spine network architectures
• Low-latency InfiniBand fabrics and high-performance computing (HPC) nodes

Key specifications

• Connector type: QSFP28 male to QSFP28 male
• Cable type: Active optical cable (AOC)
• Rated data rate: 100 Gbit/s full-duplex
• Cable length: 2 meters
• Physical form factor: Slim, lightweight optical assembly for dense cabling
• Compatibility: Designed for QSFP28 ports and InfiniBand environments

How to use

Insert each QSFP28 connector into the corresponding QSFP28 port until the latch engages; ensure the cable is oriented correctly and avoid excessive bending at the connector boot. For best performance, route the cable to minimize sharp bends and mechanical strain, and keep it away from sources of electromagnetic interference. No separate transceivers are required; the AOC is ready for immediate use when plugged into compatible ports. Verify link status on connected devices and check system documentation for any required port configuration or firmware compatibility notes.

Recommendations

For reliable operation, use this 2 m BlueOptics AOC within standard rack installations and avoid repeated insertion/removal cycles beyond vendor-specified limits. Maintain a minimum bend radius as recommended by the manufacturer, and ensure connected devices support QSFP28 100G modes and InfiniBand signalling for optimal interoperability.