AOC fiber cable CBO QSFP-100G-AOC-20M — QSFP+ to QSFP+, 100G, 20 m

AOC fiber cable CBO QSFP-100G-AOC-20M is a pre-terminated active optical cable featuring QSFP+ to QSFP+ connectors and a 20 meter reach designed for short-reach interconnects in data center and rack environments. The cable supports 100G transmission with reduced power consumption and lower latency compared with separate optical transceivers plus patch fibers. It is intended for direct connections between high-speed switches, routers and servers where reliable 100 gigabit links and predictable performance are required.

Advantages

The active optical design integrates optical transceiver electronics within the cable ends, eliminating the need for separate modules and patch cords while maintaining signal integrity at 100G. With a 20 m length it simplifies cable management across adjacent racks and within data halls, while offering lower power draw and thermal load compared with discrete transceiver solutions. The QSFP+ end-to-end connection supports industry-standard 100G link rates and provides stable, low-latency performance suitable for high-throughput environments.

Suitable for

• High-speed switch-to-switch interconnects in data centers
• Router and aggregation switch uplinks requiring 100G
• Direct server-to-switch 100G connections
• Top-of-rack and end-of-row cabling within 20 m span

Key specifications

• Connector type: QSFP+ to QSFP+
• Data rate: 100 Gbps
• Length: 20 meters
• Cable type: Active optical cable (AOC)
• Typical use: Short-reach data center interconnect
• Performance: Low latency, reduced power compared with discrete transceivers

How to use

Install the AOC fiber cable by inserting each QSFP+ connector into the appropriate QSFP+ port on your networking devices, ensuring proper alignment and full engagement until the latch secures. No separate transceiver modules or fiber patch cords are required. After physical installation, verify link status and negotiate speed on connected devices; standard network equipment will detect the 100G link if QSFP+ ports are supported and enabled. Route the cable to avoid sharp bends and mechanical stress, maintaining manufacturer-recommended bend radii for optical cables.

Recommendations

Use this QSFP+ AOC for short-reach 100G links in data center racks and between adjacent rows. Confirm compatibility with device QSFP+ ports and firmware, avoid tight routing or kinking, and follow ESD precautions when handling connectors to ensure reliable long-term operation.