AOC CBO SFP+ Active Optical Cable 10G 1m compatible with Zyxel (SFP-AOC-10G-1M)

The AOC CBO SFP+ Active Optical Cable 10G 1m compatible with Zyxel (SFP-AOC-10G-1M) is a 1‑metre active optical direct-attach cable designed for short‑reach 10Gbps connections between SFP+ ports on switches, servers and storage devices. The cable uses optical transceivers integrated into a single assembly to deliver low latency, high signal integrity and immunity to electromagnetic interference compared with copper twinax alternatives. It is intended for rack‑level interconnects in data centres and high‑density networking environments where reliable, high‑speed links are required over a short distance.

Advantages

This 10G active optical cable provides consistent 10 Gigabit performance with reduced power consumption relative to discrete transceiver plus fibre-patch solutions. Integrated active optics lower bit error rates and maintain stable signal quality over the 1 m span. The optical construction eliminates near‑end crosstalk and susceptibility to external electrical noise, which simplifies grounding and electromagnetic compatibility considerations in dense rack deployments. Plug-and-play form factor ensures straightforward installation and immediate link negotiation with compatible SFP+ ports.

Suitable for

• Interconnecting SFP+ ports on switches and routers within the same rack or adjacent racks
• Short‑reach links between servers and storage arrays in data centre cabinets
• High‑density aggregation and top‑of‑rack networking requiring 10Gbps throughput
• Environments where reduced electromagnetic interference and low latency are important

Key specifications

• Data rate: 10 Gbps
• Length: 1 metre
• Connector type: SFP+ integrated active optical assembly (fixed cable)
• Transmission medium: optical (active)
• Typical use: short‑reach direct attach between SFP+ ports
• Latency: low, suitable for latency‑sensitive links

How to use

Power down is not required in most modern SFP+ ports; insert each SFP+ connector firmly into the corresponding port until it latches. Verify link LEDs on connected devices and confirm 10Gbps negotiation in the device interface or management console. When removing, press the release latch and pull straight out to avoid stressing the connector. Route the 1 m cable to avoid tight bends and mechanical strain; maintain the cable bend radius recommended by the manufacturer to preserve optical performance.

Recommendations

Use this active optical cable for short interconnects inside racks or between adjacent racks. Avoid exposure to sharp bends, excessive tensile force or environments with temperatures beyond the equipment specifications. Check device compatibility lists for Zyxel SFP+ port support and ensure firmware or driver updates as required for optimal link negotiation and stability.