AOC CBO QSFP-100G-AOC-20M Active Optical Cable 20 m, QSFP+ to QSFP+ 100G

AOC CBO QSFP-100G-AOC-20M Active Optical Cable 20 m is a factory-assembled QSFP+ to QSFP+ 100G optical interconnect designed for high-density data center environments and enterprise networks. The 20-metre active optical cable provides 100 Gigabit per second full-duplex bandwidth with low latency and stable signal integrity over multimode optical fiber. With plug-and-play QSFP+ connectors and an integrated optical transceiver design, the cable reduces the need for separate transceiver modules and minimizes electromagnetic interference compared to equivalent copper links.

Advantages

The cable integrates the transceiver electronics and optical fiber into a single pre-terminated assembly, simplifying installation and reducing cabling errors. It supports high-density QSFP+ ports and delivers consistent 100G performance with low latency and reduced heat dissipation compared to some active copper options. As an optical solution, it provides electrical isolation and immunity to electromagnetic interference, which helps maintain signal quality in dense rack environments.

Suitable for

• Switch-to-switch 100G interconnects in data centers
• Server-to-switch or server-to-storage 100G links
• High-bandwidth, low-latency network uplinks and spine-leaf architectures
• Environments requiring reduced electromagnetic interference and electrical isolation

Key specifications

• Connector type: QSFP+ to QSFP+
• Data rate: 100 Gigabit per second (aggregate)
• Length: 20 metres
• Cable type: Active Optical Cable (AOC) with integrated optical transceivers
• Latency: low-latency optical transmission suitable for high-performance networking
• Compatibility: designed for QSFP+ ports supporting 100G links
• Immunity: reduced electromagnetic interference compared with copper alternatives

How to use

Install the AOC by inserting each QSFP+ connector into the corresponding QSFP+ port on your networking equipment until the latch engages. The assembly is factory-terminated and requires no additional transceiver modules or fiber termination. After insertion, verify the link status on connected devices and configure the network interfaces according to your switch or host settings. For safe handling, avoid sharp bends and maintain the manufacturer’s recommended minimum bend radius for optical fiber.

Recommendations

Use the cable in supported QSFP+ 100G ports and in environments that respect optical cable bend radius and airflow requirements. Store and route the cable to avoid kinks and excessive compression, and check device compatibility for QSFP+ link settings such as speed and lane mapping before deployment.