AOC CBO QSFP-100G-AOC-10M active optical cable 10 m for QSFP28 100G connections

The AOC CBO QSFP-100G-AOC-10M active optical cable is a 10-metre solution for QSFP28 100G ports that integrates optical transceivers into the cable assembly. Designed to deliver 100 Gigabit connectivity over a short reach, this cable reduces electromagnetic interference and lowers power consumption compared with equivalent copper assemblies. The plug-and-play design supports high-bandwidth links between switches, servers and other QSFP28-equipped devices, making it suitable for data centre topologies and dense rack environments.

Advantages

This active optical cable provides full 100G data rate with module-integrated optics that simplify installation and remove the need for separate transceiver modules. The optical medium enables reduced crosstalk and electromagnetic emissions while offering lower thermal load and power usage than comparable passive copper solutions. Being a factory-terminated AOC, it offers consistent optical performance, predictable latency and minimal maintenance requirements for short-range high-speed links.

Suitable for

• Switch-to-switch 100G interconnects in data centres
• High-bandwidth server uplinks and leaf-spine fabrics
• Patch connections in racks and top-of-rack deployments
• Short-reach optical links where QSFP28 ports are available

Key specifications

• Connector type: QSFP28 form factor compatible plug on both ends
• Data rate: 100 Gigabit per second
• Length: 10 metres of factory-integrated optical cable
• Transceiver type: module-integrated active optical transceivers within the cable
• Transmission medium: multimode/mode type suitable for short-reach 100G AOC (factory specified)
• Typical use range: short-reach data centre links (approximately 10 m)

How to use

Install the cable by inserting each QSFP28-compatible plug into the corresponding 100G QSFP port on switches or servers until the latch engages. No separate transceiver modules or additional configuration are required for standard QSFP28 ports that support AOC assemblies. Verify link status through the host device management interface and confirm the 100G link speed and optics health. For hot-plug operations, follow equipment vendor guidance to avoid port errors during insertion or removal.

Recommendations

Route the cable to avoid sharp bends and maintain the minimum bend radius specified by the equipment vendor. Keep connectors and ports free of dust and contaminants; use dust caps when the cable is not connected. Ensure compatible QSFP28 ports and firmware support for AOC assemblies to guarantee full performance and link stability.