Active Optical Cable CBO SFP28-AOC-30M 30 m SFP28 25Gb/s QSFP28-compatible

The Active Optical Cable CBO SFP28-AOC-30M is a 30-meter SFP28-compatible AOC engineered for 25 Gb/s links. It integrates SFP28 electrical interfaces with an optical fiber medium to deliver direct server-to-switch or switch-to-switch connectivity without separate transceivers. The cable reduces electrical power consumption and improves signal integrity compared with long copper assemblies, making it suitable for high-density data center topologies and short-reach aggregation links.

Advantages

This active optical cable supports 25 Gb/s per channel throughput while maintaining low latency and compact SFP28 form-factor compatibility. By integrating optical conversion within the cable ends, it eliminates the need for separate transceiver modules, lowers system power draw, and reduces heat load in racks. The fiber medium provides reliable transmission over the full 30 m length with immune performance against electromagnetic interference and improved signal margin for high-speed links.

Suitable for

• Direct server-to-switch connections in top-of-rack deployments
• Switch-to-switch connections in aggregation and spine layers
• High-density patching in data center racks and network closets
• Low-latency short-reach interconnects where power efficiency is important

Key specifications

• Connector type: SFP28 on both ends (SFP28-compatible)
• Maximum data rate: 25 Gb/s per lane
• Cable length: 30 meters
• Medium: multi-mode optical fiber with active optical transceiver electronics built into cable ends
• Typical latency: low, suitable for latency-sensitive applications
• Form factor: SFP28-compatible slim transceiver housing integrated into AOC ends

How to use

Install the Active Optical Cable by inserting each SFP28 connector into the corresponding SFP28 port on network equipment until the latch clicks. Ensure network interfaces are powered and configured for 25 Gb/s operation or auto-negotiation as supported by the switch or NIC. No additional transceiver modules are required; the cable provides the optical link and will be recognised by most systems that support SFP28 AOCs. Route the cable to avoid sharp bends and secure it to reduce strain on the connectors.

Recommendations

For reliable operation, use the cable within its specified 30 m range, avoid exceeding minimum bend radius near the connector, and maintain a clean environment around connector interfaces. Verify compatibility with target switch and server vendor documentation for SFP28 AOC support and update device firmware if necessary to ensure proper recognition and performance.