Active Optical Cable CBO AOC-SFP-10G-30M-BO — 30 m SFP+ 10 Gbit/s

Active Optical Cable CBO AOC-SFP-10G-30M-BO — 30 m SFP+ 10 Gbit/s is a factory-assembled SFP+ active optical cable engineered to provide reliable 10 Gbit/s connectivity over a 30-meter span. The cable combines SFP+ transceivers and a fixed OM3/OM4-compatible multimode fiber link in a single lightweight assembly, eliminating the need for separate transceivers and patch cords. It is intended for use where low power consumption, reduced weight, and high-density cabling are priorities in network environments such as data centers and server rooms.

Advantages

This BlueOptics AOC delivers 10 Gbit/s performance with lower power consumption compared with equivalent copper direct-attach cables at similar lengths. The integrated design reduces component count and simplifies installation, while the optical medium provides immunity to electromagnetic interference and improved signal integrity over the full 30 m range. The cable’s compact SFP+ connector housings and flexible jacket support high-density rack deployments and easier cable management.

Suitable for

• Interconnects between switches and top-of-rack or end-of-row devices
• Server-to-switch connections within data centers and server rooms
• Aggregation links in high-density network cabinets
• Environments requiring reduced weight and lower heat dissipation compared to copper cabling

Key specifications

• Form factor: SFP+ integrated active optical cable
• Maximum data rate: 10 Gbit/s (per link)
• Nominal length: 30 meters
• Transmission medium: multimode optical fiber compatible with OM3/OM4 systems
• Connector type: SFP+ plug on both ends (hot-pluggable)
• Typical power consumption: lower than equivalent long-length copper DACs (device-dependent)
• Immunity: resistant to electromagnetic interference due to optical transmission

How to use

Install the AOC by inserting each SFP+ connector into the SFP+ port of the corresponding network devices until the latch engages. No separate transceivers or fiber patch cords are required. Verify link LEDs or device status indicators to confirm a successful link. If necessary, check network device compatibility and any vendor-specific firmware or port settings that affect SFP+ active cables. For removal, depress the connector latch and withdraw the module carefully to avoid stressing the cable or port.

Recommendations

Route the cable to avoid sharp bends and maintain the manufacturer’s minimum bend radius; avoid tight cable ties that can compress the fiber. Use in temperature-controlled equipment racks and verify compatibility with the switch or server vendor when operating at full 10 Gbit/s rates. For optimal airflow and ease of maintenance, label both ends and bundle consistently with other rack cabling.