Barrow Multi-Link Adapter 90° 14mm for AD Hardtube White TWT90KNS-K14

Barrow Multi-Link Adapter 90° 14mm for AD Hardtube White TWT90KNS-K14 is a compact 90-degree connector designed for 14 mm rigid tubing in custom PC water-cooling systems. The adapter creates a neat, low-profile directional change between hardtube runs, allowing builders to route coolant lines with precision while maintaining a consistent aesthetic in white finish. It is compatible with AD-style hardtube fittings and is intended to integrate into multi-segment tubing layouts where space and alignment require a fixed-angle transition.

Advantages

This 90° multi-link adapter offers a compact footprint and precise angle control for rigid 14 mm tubing, reducing stresses on joints and improving overall loop appearance. The white finish provides a uniform look when paired with matching fittings and tubes, and the adapter’s construction supports tight routing in confined chassis areas. It simplifies complex bends into a single reliable connection, helping to maintain consistent flow paths and reducing the need for soft tubing or multiple angled fittings.

Key specifications

• Angle: 90 degrees for fixed directional change
• Compatible tube outer diameter: 14 mm rigid hardtube
• Finish: white
• Connection type: AD hardtube fitting interface
• Form factor: compact multi-link adapter for tight routing

How to use

Ensure both tubing ends and mating fittings are clean and free of debris before installation. Insert the 14 mm hardtube into the adapter according to the AD fitting system’s guidelines, securing each connection as specified for your fittings—typically by pushing the tube into the adapter until a secure seal is achieved and verifying alignment. Use appropriate torque and follow the manufacturer instructions of your fittings to avoid over-tightening. Check for proper seating and perform a leak test after completing the loop and before powering the PC components.

Usošanas ieteikumi

Install the adapter in locations where a fixed 90° turn will reduce tubing stress and improve routing. Pair with compatible AD hardtube fittings and use a leak test procedure after assembly. Avoid forcing tubes at angles not supported by the adapter and ensure the chosen chassis area provides sufficient clearance for the assembly.