Audio cable Omnitronic 3021050A 6.3mm mono jack, 1 m

Omnitronic 3021050A is a 1 m audio cable fitted with a 6.3 mm mono (TS) jack on each end. It provides a direct wired connection for instruments, mixers and other audio devices that accept a standard mono jack. The cable's length and connector type make it suitable for short runs on stage, in rehearsal rooms and in studio patching where a simple, reliable mono signal path is required.

Advantages

The cable offers a compact, low-profile connection with a standard 6.3 mm mono jack that is widely compatible with many audio devices. Its 1 m length reduces excess cable on stage and in the studio, helping to keep setups tidy. The construction focuses on providing a stable, interference-minimized signal for unbalanced mono audio connections.

Suitable for

Key specifications

How to use

Insert the 6.3 mm mono jack firmly into the instrument output, amplifier input or device jack until it seats. Ensure both ends are fully connected before powering devices to avoid pops or noise. Route the cable to avoid tight bends and minimize cross-over with power cables to reduce potential interference. For temporary setups, coil any excess neatly to prevent tripping or tangling.

Recommendations

For best performance, keep cable runs as short as practical for unbalanced mono connections and avoid parallel routing alongside mains power lines. Periodically inspect connector contacts and cable jacket for wear; replace the cable if connectors become loose or the jacket shows damage.