AOC CBO SFP+ BlueOptics BO353503J7M 10G active optical cable, 7 m

AOC SFP+ BlueOptics BO353503J7M is an active optical cable (AOC) engineered for 10 Gigabit Ethernet connections over a 7 m length. Designed to plug directly into SFP+ ports, this cable creates a low-latency, high-bandwidth link between switches, servers and storage devices in data centers and enterprise networks. The optical design reduces electromagnetic interference compared with copper alternatives and the compact SFP+ transceiver form factor simplifies deployment in dense rack environments.

Advantages

The 7 m BlueOptics AOC provides 10G data throughput with minimal signal loss and low latency suitable for demanding network applications. Because it uses active optical transceivers integrated at each end, the cable maintains signal integrity over its full length while keeping power consumption and heat generation low. Its SFP+ form factor enables direct insertion into compatible ports without separate transceiver modules, reducing installation time and space requirements. The optical medium reduces susceptibility to electromagnetic interference and ground loop issues common with copper cabling.

Suitable for

• Interconnecting SFP+ ports on switches and routers within racks
• Server-to-switch links in data centers and server rooms
• Storage area network (SAN) uplinks and aggregation links
• Short-reach 10 Gigabit Ethernet connections where fiber runs of 7 m are required

Key specifications

• Form factor: SFP+ active optical cable
• Nominal data rate: 10 Gigabit Ethernet
• Length: 7 meters
• Connector: SFP+ plug on both ends
• Medium: multimode/mode-optimized active optical link
• Typical latency: low, suitable for high-performance switching and server interconnects
• EMI performance: immune to electromagnetic interference compared with copper

How to use

Install the AOC by inserting each SFP+ connector into the corresponding SFP+ slot on your networking devices until the latch engages. Ensure both devices support 10G operation on the SFP+ ports and that firmware or port settings are configured for the correct link speed and duplex. No separate transceiver or fiber patch cables are required; the cable is a single assembly with active optical transceivers built in. When disconnecting, press the release latch and pull the connector straight out to avoid stressing the cable or port.

Recommendations

For reliable operation, route the cable to avoid sharp bends and maintain the manufacturer’s minimum bend radius. Use in temperature-controlled environments typical of data centers and enterprise wiring closets. Verify compatibility with switch and server SFP+ port vendors and confirm link negotiation settings after installation. For long-term installations, periodically inspect connectors for dust and clean with appropriate optical cleaning tools if necessary.