InLine Patch Cable SF/UTP Cat.5e brown 2m

The InLine Patch Cable SF/UTP Cat.5e brown 2m is a 2-meter Category 5e twisted-pair network cable with SF/UTP shielding and RJ-45 connectors on both ends. It supports Gigabit Ethernet (1 Gbit/s) at up to 125 MHz and is intended for connecting switches, routers, sockets, patch panels and network cards in structured cabling and local area networks. The brown jacket identifies the cable visually within installations.

Advantages

This Cat.5e SF/UTP patch cable provides shielding to reduce electromagnetic interference and improve signal integrity compared with unshielded cables. With RJ-45 connectors on both ends and compatibility with 10/100/1000Base-T(X), it enables straightforward plug-and-play connections for devices that require Gigabit speeds. The 2 m length is suitable for short runs in racks, patch panels or desktop setups.

Suitable for

• Connecting switches and routers
• Patch panels and wall sockets
• Network cards in PCs or servers
• Gigabit Ethernet (1 Gbit/s) links in LANs

Key specifications

• Standard: Cat.5e
• Shielding: SF/UTP
• Length: 2 m
• Connectors: RJ-45 to RJ-45
• Data rate: up to 1000 Mbit/s
• Maximum frequency: 125 MHz
• Cabling technology: 10/100/1000Base-T(X)
• Colour: Brown

How to use

Plug one RJ-45 connector into the network device (switch, router or network card) and the other connector into the corresponding port on the patch panel, wall socket or another device. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid tight bends and mechanical stress. For proper performance, keep the cable away from strong electrical noise sources where possible.

Recommendations

For reliable Gigabit connections, use this Cat.5e SF/UTP patch cable for short links up to 2 m within racks, between patch panels and devices, or on desktops. Avoid excessive bending radius and do not subject connectors to strain; consider using cable management in dense installations.